High Efficiency Water and Steam Heat Exchanger

Heat Exchangers McMaster-Carr

Also known as shell and tube heat exchangers, these transfer heat using liquid or steam that flows through the shell to heat or cool liquid in the tubes. High-Efficiency Heat Exchangers Stacked, corrugated plates maximize contact with liquid or steam flowing through these brazed plate heat exchangers for faster heat transfer than shell and tube heat exchangers.

Liquid Heat Exchangers McMaster-Carr

Place these heat exchangers in open tanks to heat or cool their contents by transferring heat from liquid or steam that flows through passageways in the panel. High-Pressure Heat Exchangers With more than three times the pressure rating of standard heat exchangers, these are often used for high-pressure condensing, evaporating, heating, and cooling. Steam Consumption of Heat Exchangers Spirax SarcoA shell and tube heat exchanger used to heat water for space heating (using either steam or water) is often referred to as a non-storage calorifier. (A storage calorifier, as shown in Figure 2.13.1, is constructed differently, it usually consists of a hot water storage vessel with a primary heating

Steam-To-Water Heaters AERCO

In 1949, AERCOs founder, Henry Angelery, had an idea for a water heater that offered accurate temperature control without storage tanks. From this idea, he designed and manufactured the worlds first compact, tankless water heater paving the way for the thousands of semi-instantaneous and instantaneous heating units that are available today. Based on Angelerys original concepts for the heat exchanger design, fully modulating steam High Efficiency Steam ExchangersThe XE steam exchanger systems are available in multiple sizes:Building heat from 10 - 1700 gpm. Domestic water from 10 - 200 gpm. Units can be duplexed for higher capacity and redundancy. High efficiency operation on steam pressures up to 175 psig. Duplex 400 gpm Building Heat on 60 psi steam Duplex 275 gpm Building Heat on 100 psi steam